Aug 11 2017

Intelligent water meter/IC card water meter Battery

IC Card Water meter/intelligent water meter is an intelligent water meter products, at this stage has begun to promote the application of many pilots, because it is necessary to install the battery, to work, display data, so some users have produced such questions: if the IC card water meter/intelligent water meters is power off, will the water supply be cut off?

Multi Jet Water Meter     Prepaid water meter  

intelligent water meters need to recharge to buy a drink to use, after buying water on the meter inserted IC card, to water. However, in the use of the process, because of forgetting to replace the battery, many users found that the insertion of IC card, LCD screen has not shown the number, at this time will occur two kinds of possible problems, one is inserted card, water meter does not show the number, but the supply of normal tap. There will also be a situation, that is, immediately water. What are the reasons for these two different situations? This is because the IC card water meter/intelligent water meter motherboard battery and panel battery is different, if the LCD is not displayed, and will not affect the user normal water, at this time the user should replace the battery as soon as possible. And if the real water supply in the home, then there is almost only one reason, that is, intelligent meter monitoring to run out, automatic to the brake plate issued a signal.

 AWWA Standard Water MeterRemote Reading Water Meter

If the home is out of water, and the water meter screen after the card does not show, there may be battery exhausted, can not work, you can replace the same type of battery. The following is a description of the replacement battery steps:
1, cut the battery compartment seal, remove the fixed cover of the screw, remove the battery. The battery compartment is on the bottom of the meter.

Woltman Type Water Meter

Single Jet Dry Dial Brass AMR Remote Reading Water Meter

Single Jet Dry Dial Brass AMR Remote Reading Water Meter

2, press the buckle, unplug the connector, disconnect the battery snap connection. Water meter used for two 3V lithium battery, model CR14505E two series, the battery and the water meter by the buckle connection.
3, the new battery to buy, pay attention to whether the positive and negative batteries with the original battery, mainly to see the connection line. If correct, plug the buckle with the water meter can be inserted.
5, at this time without worry on the battery cover cover, first with their own water card into the water meter, insert the water meter after the solenoid valve action, the screen shows the relevant figures, that the battery work properly, the water meter can work. Note: There may be a small amount of water in the water meter.

Ultrasonic Water Meter
6, cover the battery cover, screw on the screw, if the water meter has been replaced, call the property staff to change the water meter on it

 

Dry Type Drinking Cold Water Meter

Dry Type Drinking Cold Water Meter